Sample Problem SP1-2 Angular Shapes
Chapter 2 Two-Dimensional Sketching
Fundamentals of Orthographic Views
Orthographic Views with Inventor
Bottom-Up and Top-Down Assemblies
Free Move and Free Rotate Tools
Editing a Part within an Assembly Drawing
Chapter 6 Threads and Fasteners
Thread Callouts—ANSI Unified Screw Threads
Creating Threaded Holes Using the Hole Tool
Sizing a Threaded Hole to Accept a Screw
Flat Head Screws—Countersunk Holes
Drawing Fasteners Not Included in the Content Center
Chapter 7 Dimensioning a Drawing
Terminology and Conventions—ANSI
Radius and Diameter Dimensions
Dimensioning Counterbored, Countersunk Holes
Symmetrical and Centerline Symbols
Dimensioning Orthographic Views
Understanding Plus and Minus Tolerances
Creating Plus and Minus Tolerances
Chain Dimensions and Baseline Dimensions
Choosing a Shaft for a Toleranced Hole
Visual Presentations of the Hole and Shaft Tolerances
Geometric Tolerances Using Inventor
Drawing Shafts and Pins Using the Tools Under the Design Tab
Drawing Gears Using the Gear Tool
Chapter 13 Sheet Metal Drawings
The following online chapter and appendix are available at pearsondesigncentral.com