You reload a router with a configuration register setting of 0x2101. What will the router do when it reloads?
Which of the following commands provides the product ID and serial number of a router?
show license
show license feature
show version
show license udi
Which command allows you to view the technology options and licenses that are supported on your router along with several status variables?
show license
show license feature
show license udi
show version
You want to send a console message to a syslog server, but you only want to send status messages of 3 and lower. Which of the following commands will you use?
logging trap emergencies
logging trap errors
logging trap debugging
logging trap notifications
logging trap critical
logging trap warnings
logging trap alerts
IPv6 unicast routing is running on the Corp router. Which of the following addresses would show up with the show ipv6 int brief
command?
Corp#sh int f0/0
FastEthernet0/0 is up, line protocol is up
Hardware is AmdFE, address is 000d.bd3b.0d80 (bia 000d.bd3b.0d80)
[output cut]
FF02::3c3d:0d:bdff:fe3b:0d80
FE80::3c3d:2d:bdff:fe3b:0d80
FE80::3c3d:0d:bdff:fe3b:0d80
FE80::3c3d:2d:ffbd:3bfe:0d80
A host sends a type of NDP message providing the MAC address that was requested. Which type of NDP was sent?
Each field in an IPv6 address is how many bits long?
What does the command routerA(config)#line cons 0
allow you to perform next?
Which two statements describe the IP address 10.16.3.65/23? (Choose two.)
On which interface do you configure an IP address for a switch?
int fa0/0
int vty 0 15
int vlan 1
int s/0/0
Which of the following is the valid host range for the subnet on which the IP address 192.168.168.188 255.255.255.192 resides?
Which of the following is considered to be the inside host’s address after translation?
Your inside locals are not being translated to the inside global addresses. Which of the following commands will show you if your inside globals are allowed to use the NAT pool?
ip nat pool Corp 198.18.41.129 198.18.41.134 netmask 255.255.255.248
ip nat inside source list 100 int s0/0 Corp overload
debug ip nat
show access-list
show ip nat translation
show ip nat statistics
How many collision domains are created when you segment a network with a 12-port switch?
Which of the following commands will allow you to set your Telnet password on a Cisco router?
line telnet 0 4
line aux 0 4
line vty 0 4
line con 0
Which router command allows you to view the entire contents of all access lists?
show all access-lists
show access-lists
show ip interface
show interface
What does a VLAN do?
If you wanted to delete the configuration stored in NVRAM, choose the best answer for the Cisco objectives.
erase startup
delete running
erase flash
erase running
Which protocol is used to send a destination network unknown message back to originating hosts?
Which class of IP address provides 15 bits for subnetting?
There are three possible routes for a router to reach a destination network. The first route is from OSPF with a metric of 782. The second route is from RIPv2 with a metric of 4. The third is from EIGRP with a composite metric of 20514560. Which route will be installed by the router in its routing table?
Which one of the following is true regarding VLANs?
How many broadcast domains are created when you segment a network with a 12-port switch?
What protocols are used to configure trunking on a switch? (Choose two.)
What is a stub network?
Where is a hub specified in the OSI model?
What are the two main types of access control lists (ACLs)? (Choose two.)
Which of the following is the best summarization of the following networks: 192.168.128.0 through 192.168.159.0?
What command is used to create a backup configuration?
copy running backup
copy running-config startup-config
config mem
wr net
1000Base-T is which IEEE standard?